Ken-tool Bendix ADB22X-V Air Disc Brakes Manuel d'utilisateur télécharger pdf (Page 19)

5.1 AIR DISC BRAKE SHIELD KIT

5.1.1 CAUTION: Follow all safe maintenance

practices, including those listed on page two of

this document. Park the vehicle (by other means

than the foundation brakes) on level ground and

chock the wheels.

Note: Most torque plates manufactured after January 1,

2007 have the required torque plate tabs to permit these

shields to be mounted.

This shield kit includes a brake pad shield, a rotor shield

and the required attaching hardware for use in Bendix

ADB22X

™

and ADB22X-V

™

Air Disc Brake applications

where external contamination and excessive road debris is

a concern. Brake pad and rotor shields can greatly reduce

damage and/or premature wear of pads and rotors under

these conditions.

During installation, verify that once the shield(s) are

installed they will not come into contact with any vehicle

components, suspension, housings, etc. through the full

range of motion of the wheel. Keep in mind the particular

use of the vehicle, the orientation of the brake on the axle

and torque plate, the proximity of other axles, and/or the

wheel/tire being used.

Washer

Spring

Clip

Pad Shield

Rotor Shield

Fastener

Torque

Plate

Fastener

Rotor Shield

FIGURE 31 - DRIVE OR STEER AXLE EXPLODED VIEW WITH

INSET SHOWING ROTOR SHIELD INSTALLATION

5.1.2 Remove and discard the spring clip and washer

from the pad retainer pin. Remove and retain the

retainer bar and retainer pin. Position the pad shield

as shown and re-insert the retainer bar. Install

the retainer pin. Use the included spring clip and

washer to secure the retainer pin. Check that the

pad shield is held securely in place by the retainer

bar. See Figures 31 or 32.

Washer

Spring

Clip

Pad Shield

Rotor Shield

Fastener

Lock

Washer

Torque

Plate

Fastener

(with Washer)

Rotor

Shield

FIGURE 32 - TRAILER AXLE EXPLODED VIEW WITH INSET

SHOWING ROTOR SHIELD INSTALLATION

5.1.3 Drive or Steer Axle Rotor Shields (See Figure

31). Position the rotor shield between the torque

plate and the rotor. The supplied cap screws

pass through the mounting tabs in the torque plate

and install into the shield. Torque cap screws to

44 Ft. Lbs. (528 in. lbs.).

5.1.4 Trailer Axle Rotor Shields (See Figure 32).

Position the rotor shield with the torque plate

between the shield and the rotor. With one

(supplied) lock washer in place on each cap screw,

pass the screws through the shield before mounting

onto the threaded torque plate holes. Torque the

cap screws to 24 Ft. Lbs. (288 in. lbs.).

Note: The installation of air disc brake shields does not

eliminate the need for periodic maintenance and inspection

of the air disc brake and entire wheel end for damage and/

or wear. In addition, the truck and trailer manufacturer’s

speciﬁ c criteria for the brake shield requirements on air

disc brakes should be consulted before either installing or

removing air disc brake shields from a wheel end(s).

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Ken-tool Bendix ADB22X-V Air Disc Brakes Manuel d'utilisateur Page 19

Commentaires sur ces manuels