Ken-tool Bendix ADB22X-V Air Disc Brakes Manuel d'utilisateur télécharger pdf (Page 28)

FIGURE 59 - OFF VEHICLE TAPPET BOOT INSTALLATION TOOL

(B3, WITH T24 INSTALLED, B4)

FIGURE 60 - OFF VEHICLE TAPPET BOOT INSTALLATION

FIGURE 61 - OFF VEHICLE TAPPET INSTALLATION

5.5.19 Check that the tappets are ﬁ rmly attached to the

bushings by gripping and turning them by hand.

Properly installed tappets are able to turn, but are

securely held onto the tappet bushings. Using the

shear adapter, extend the threaded tubes outward,

and check that the boot is held in place. Retract

the tappet.

5.5.20 Re-install the caliper/carrier assembly, if it was

removed from the vehicle (See Section 5.3.).

5.5.21 Re-install the brake pads (See Section 5.2).

FIGURE 56 - ON VEHICLE TAPPET AND BOOT INSTALLATION

TOOL (B1 - WITH T24 INSTALLED, B2)

161

FIGURE 57 - ON VEHICLE TAPPET BOOT INSTALLATION

FIGURE 58 - ON VEHICLE TAPPET INSTALLATION

To install tappet and boot assemblies where the caliper

is removed from the vehicle:

5.5.18 See Figures 59, 60 and 61. Retract the tappets,

as needed, in order to have room to install the

tappets. Use tool B3, comprising tools T1, T2, and

T3 to press the boot into position. The tool is then

reversed, and the nylon disc (T24) is inserted into

the T1 “cup” (combination tool ‘B4’). Holding the

T1 handle, turn the nut on the T3 tool to fully seat

the tappet onto the tappet bushing (161).

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 39 40

Pas de commentaire

Ken-tool Bendix ADB22X-V Air Disc Brakes Manuel d'utilisateur Page 28