Ken-tool Bendix ADB22X-V Air Disc Brakes Manuel d'utilisateur Page 18

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 40
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 17
18
5.0.1 GENERAL INFORMATION ABOUT
BENDIX
®
AIR DISC BRAKE MAINTENANCE
When working on Bendix
®
Air Disc brakes, please note
the following:
Read and follow the Safe Maintenance Practices on
page two.
Depending on the particular axle, the technician may
need to remove the caliper/carrier to allow suffi cient
access to perform the work.
CAUTION: When using a hoist to support the air
disc brake, do not attempt to use the pad retainer
bar as a bracing point as it is not designed to
support the weight of the brake. Use instead a
brace (or chain) wrapped around the entire brake
to attach the hoist.
Kit
See
Section
Remove
Brake Pads?
Section 5.2
Remove Caliper/
Carrier from
Vehicle?
Section 5.3
Remove
Actuator from
Caliper?
Section 5.4
Dust Shields Section 5.1 Not Typically NA NA
Pad Kit (axle set) Section 5.2 Yes No No
Caliper Kit (rationalized) Section 5.3 Yes Yes Yes
Carrier Kit Section 5.3 Yes Yes Yes
Service Actuator Section 5.4 No Not Typically Yes
Spring Brake Actuator Section 5.4 No Not Typically Yes
Tappet/Boot Kit (wheel end kit) Section 5.6 Yes Typically Typically
Guide Pin, Seal and Boot Kit (wheel end kit) Section 5.7 Yes Typically Typically
Hubs Section 5.8 Yes Yes Yes
Splined Disc
®
Rotor Attaching Kit Section 5.9 Yes Yes Yes
Rotor Section 5.10 Yes Yes Yes
TABLE 3 - OTHER REQUIRED SECTIONS FOR MAINTENANCE KITS
When replacing bearings — or for any other
maintenance procedure where the technician needs
to remove the caliper/carrier assembly from the vehicle
to perform the maintenance — replacement caliper/
carrier bolts will be required. Please note that due
to the high torque required, the original bolts cannot
be reused. The bolts are available from the vehicle
manufacturer.
WARNING: Not all wheels and valve stems are
compatible with Bendix Air Disc Brakes. Use only
wheels and valve stems approved by the vehicle
manufacturer to avoid risk of valve stem shear and
other compatibility issues.
5.0.2 SERVICE DVD
Order part number BW7356 for a DVD showing the full
set of maintenance procedures included in this Service
Data sheet.
Vue de la page 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Commentaires sur ces manuels

Pas de commentaire