Ken-tool Bendix ADB22X-V Air Disc Brakes Manuel d'utilisateur télécharger pdf (Page 37)

5.7.9 Re-install the air disc brake (See Section 5.3).

Supporting the air disc brake by all necessary

means, attach the brake to the anchor plate

using six bolts and washers as required (Bendix

recommends the original bolts not be re-used).

Torque to vehicle manufacturer's speciﬁ cations.

If torque values and bolts are not speciﬁ ed by the

vehicle manufacturer, then torque according to the

chart below. Be sure to select bolts with the same

thread pitch, length and grade as originally provided

from vehicle manufacturer.

5.7.10 Reinstall the brake pads (See Section 5.2).

FIGURE 91 - FASTENERS INSTALLED

Air Disc Brake Attachment Hardware

Torque Plate Manufacturer Fastener Torque

Bendix Axial

Carrier Torque Plate

Fastener: M20 x 2.5 x 60 mm Class 10.9

Washer: Requires HARDENED 3 mm

(minimum thickness) for each bolt.

If the vehicle is using a Bendix

manufactured Axial Anchor Plate, with a

thickness of 1.14 in. (29 mm) where these

bolts are assembled, then a bolt with an

overall length of 2.36 in. (60 mm) will meet

these requirements

Use the manufacturer’s recommendations.

If unavailable, use phosphate

and oil ﬁ nish fastener.

Pre-Torque: 20-60 ft-lbf [27-81 N·m]

Final Torque:

350-400 ft-lbf [475-542 N·m]

Bendix Vertical

Carrier Torque Plate

Fastener: M16 x 2.0 x 110 mm, Class 10.9

Washer: None required.

Use the manufacturer’s recommendations.

If unavailable, use plain and oil ﬁ nish fastener.

Torque: 200-220 ft-lbf [271-298 N·m]

Trailer Torque Plate

Fastener: M20 x 2.5 x L Class 10.9

Length determination:

L = Torque Plate (TP) thickness + Carrier

engagement + Washer thickness

min

= TP thickness + 24 mm + 3 mm

max

= TP thickness + 29 mm + 3 mm

Washer: Requires HARDENED 3 mm

(minimum thickness) for each bolt.

Use the manufacturer’s recommendations.

If unavailable, use phosphate

and oil ﬁ nish fastener:

Pre-Torque: 20-60 ft-lbf [27-81 N·m]

Final Torque: 350-400 ft-lbf [475-542 N·m]

Table Note: 1. The washer outside diameter must be less than 1.1in. (28.5 mm).

TABLE 7 - TORQUE PLATE FASTENERS AND TORQUE RECOMMENDATIONS (SEE MANUFACTURER’S RECOMMENDATIONS)

1 2 ... 32 33 34 35 36 37 38 39 40

Commentaires sur ces manuels

Pas de commentaire

Ken-tool Bendix ADB22X-V Air Disc Brakes Manuel d'utilisateur Page 37

Commentaires sur ces manuels